Quest V6-3.5L (VQ35DE) (2009)
Drive Belt: Service and Repair
DRIVE BELTS
Removal and Installation
REMOVAL
1. Remove engine undercover.
2. Fully loosen each belt. Refer to See: Adjustments. Remove generator and air conditioner compressor belt and then power steering oil pump belt.
CAUTION:
Grease is applied to idler pulley adjusting bolt. Be careful to keep grease away from the belts.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Make sure belts are correctly engaged with the pulley groove.
-
Clean off any oil and coolant on belts and each pulley groove.
-
Adjust belt tension. Refer to See: Adjustments.