Quest V6-3.5L (VQ35DE) (2009)
indicate an error between DLC and TCM (line 1-a in the figure below).
NOTE:
-
Diag on CAN units are not indicated on the "ECU list" when the CAN line between Diag on CAN unit and the data link connector is open.
-
For a description of Diag on CAN, refer to See: Component Tests and General Diagnostics/System Description/Diag On CAN.
2. CAN DIAG SUPPORT MNTR: Check each item on "CAN DIAG SUPPORT MNTR". Draw a line on the diagnosis sheet to indicate the error
circuit.
a. Reception item of "ECM": On "TCM", "UNKWN" is indicated. This means ECM cannot receive the signal from TCM. Draw a line to indicate
an error between ECM and TCM (line 2-a in the figure below).
NOTE:
If "UNKWN" is indicated on "TRANSMIT DIAG", then the control unit cannot transmit CAN communication signal to each unit. Draw a line
between the control unit and the splice.
b. Reception item of "AFS": On "TCM", "UNKWN" is indicated. This means AFS cannot receive the signal from TCM. Draw a line to indicate
an error between AFS and TCM (line 2-b in the figure below).
c. Reception item of "AV": "UNKWN" is not indicated. This indicates normal communication between AV and its receiving units. Do not draw
any line.