Quest V6-3.5L (VQ35DE) (2009)
Side Air Bag: Service and Repair
SIDE CURTAIN AIR BAG MODULE
Removal and Installation
REMOVAL
CAUTION:
-
Do not attempt to repair or replace damaged direct-connect SRS component connectors. If a direct connect harness connector is
damaged, the harness must be replaced.
-
Before servicing the SRS, turn the ignition switch off, disconnect both battery terminals and wait at least three minutes.
-
When servicing the SRS, do not work from directly in front of air bag module.
1. Remove headlining. Refer to See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair.
2. Disconnect front and rear side curtain air bag module connectors.
-
For removal/installation of the direct-connect SRS connectors, refer to See: Description and Operation/Direct-connect SRS Component
Connectors,
3. Remove the bolts in order starting at the front or rear, and remove the front and rear side curtain air bag modules.
CAUTION:
-
When servicing the SRS, do not work from directly in front of air bag module.
-
Do not insert any foreign objects (screwdriver, etc.) into air bag module or harness connectors.
-
Do not disassemble air bag module.
-
Do not expose the air bag module to temperatures exceeding 90°C (194°F).
-
Replace side curtain air bag module if it has been dropped or sustained an impact.
-
Do not allow oil, grease or water to come in contact with the air bag module.
INSTALLATION
Installation is in the reverse order of removal.
-
For removal/installation of the direct-connect SRS connectors, refer to See: Description and Operation/Direct-connect SRS Component