Quest V6-3.5L (VQ35DE) (2009)
Quarter Window Glass: Service and Repair
Removal And Installation (Without Rear Power Vent Windows)
SIDE WINDOW GLASS
Removal and Installation (without Rear Power Vent Windows)
REMOVAL
1. Remove the rear pillar upper finisher. Refer to See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair.
2. Remove the rear side window latch bolts.
3. Disconnect the antenna.
4. Remove the side window front bolts and glass.
CAUTION:
-
Be careful not to scratch the glass when removing.
-
Do set or stand glass on its edge. Small chips may develop into cracks.
INSTALLATION
1. Install the glass from outside to insure that it is even with the top and bottom of the opening. Tighten side window front bolts to the specified
torque.
2. Install rear side window latch bolts.
3. Connect the antenna.
4. Install rear pillar upper finisher. Refer to See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair.