Quest Minivan GLE V6-3.3L (VG33E) (1999)
2. Remove snap ring.
3. Press support bearing assembly off of drive shaft.
4. Remove dust shield.
5. Remove snap ring.
6. Separate support bearing from retainer.
INSPECTION
Thoroughly clean all parts in cleaning solvent, and dry with compressed air. Check parts for evidence of deformation and other damage.
Drive Shaft
Replace drive shaft if it is twisted or cracked.
Boot
Check boot for fatigue, cracks, and wear. Replace boot with new boot bands.
Joint Assembly (Transaxle Side)
-
Replace any parts of double offset joint which show signs of scorching, rust, wear or excessive play.
-
Check serration for deformation. Replace if necessary.
-
Check slide joint housing for any damage. Replace if necessary.
Joint Assembly (Wheel Side)
Replace joint assembly if it is deformed or damaged.
Support Bearing
Make sure wheel bearing rolls freely and is free from noise, cracks, pitting and wear.
Support Bearing Bracket
Check support bearing bracket for cracks with a magnetic exploration or dye test.
ASSEMBLY