Quest Minivan GXE V6-3.3L (VG33E) (2002)
3. Remove pulley retaining snap ring.
4. Remove the pulley and bearing assembly from compressor.
INSTALLATION
CAUTION: Do not use air tools.
1. Clean pulley bearing surface of compressor head to remove any dirt or corrosion.
2. Install pulley and bearing assembly on compressor. The bearing is a slip fit on the compressor head and, if properly aligned, it should slip on
easily.
3. Install pulley retaining snap ring with bevel side of snap ring out.
4. Install clutch hub onto compressor shaft, together with original shim(s).
5. Thread a new hub retaining bolt into end of compressor shaft.
Tighten hub retaining bolt: 11 to 14 N.m (1.2 to 1.4 kg-m, 9 to 10 ft-lb).
6. When installing a new clutch, cycle it ten times at idle to burnish the clutch and prevent slippage.
Magnet Clutch
REMOVAL
The magnet clutch coil is pressed on the front head of the compressor. Special service tools are required to remove and install the coil.
CAUTION: Do not use air tools.
1. Install coil remover Tool on the nose opening of the compressor.