Quest Minivan GXE V6-3.3L (VG33E) (2002)
Throttle Full Close Switch: Testing and Inspection
Component Inspection
CLOSED THROTTLE POSITION SWITCH
With CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Stop engine and turn ignition switch "ON".
3. Select "DATA MONITOR" mode with CONSULT-II.
4. Check indication of "CLSD THL/P SW".
Measurement must be made with closed throttle position switch installed in vehicle.
If NG, adjust closed throttle position switch. Refer to: "Basic Inspection". See: Powertrain Management/Computers and Control Systems/Testing
and Inspection/Initial Inspection and Diagnostic Overview/Initial Inspection (Basic Inspection)
5. If it is impossible to adjust closed throttle position switch in "Basic Inspection", replace closed throttle position switch.
No Tools
1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch "OFF".
3. Disconnect closed throttle position switch harness connector.
4. Check continuity between terminals 5 and 6.