Quest Minivan GXE V6-3.3L (VG33E) (2002)
4.
Disconnect the Monitor wire harness from the vehicle harness.
Check Wire Harness:
5.
Inspect the wire harness for damage (see Figure 1):
a.
If the wire harness is damaged, proceed with step 6.
b.
If the wire harness is NOT damaged, this bulletin does not apply.
^
Refer to the "EL" section of the applicable Electronic Service Manual (ESM) for diagnostic assistance.
Disassemble Video Monitor Assembly:
6.
Remove the 11 "Torx T10" screws that secure the Video Monitor Housing and Rear Cover to the Monitor Assembly (see Figure 2).
7.
Use a screwdriver to remove the Front Finisher from the Monitor by: