Quest Minivan SE V6-3.3L (VG33E) (1999)
Accelerator Pedal: Adjustments
CAUTION:
-
When removing accelerator wire, make a mark to indicate lock nut's initial position.
-
Check that throttle valve opens fully when accelerator pedal is fully depressed. Also check that returns to idle position when pedal is released.
-
Check accelerator control parts for improper contact with any adjacent parts.
-
When connecting accelerator wire, be careful not to twist or scratch its inner wire.
-
Refer to ("AUTOMATIC SPEED CONTROL DEVICE") See: Cruise Control/Adjustments for ASCD wire adjustment.
ADJUSTING ACCELERATOR WIRE
NOTE: Adjust accelerator wire with the engine warmed up to normal operating temperature and ignition switch turned to OFF.
1. Loosen lock nut, and tighten adjusting nut until throttle drum starts to move.
2. From that position turn back adjusting nut 1.5 to 2 turns, and secure lock nut.