Quest Minivan SE V6-3.3L (VG33E) (1999)
Assemble power steering pump, noting the following instructions. Make sure O-rings and oil seal are properly installed. Always install new O-rings
and oil seal.
-
Be careful of oil seal direction.
-
Coat each part with Type F Automatic Transmission Fluid when assembling.
-
Pay attention to the direction of rotor.
-
When assembling vanes to rotor, rounded surfaces of vanes must face cam ring side.
-
Insert pin 2 into pin groove 1 of front housing and front side plate. Then install cam ring 3 as shown at left.
Cam ring: D1, is less than D2