Quest Minivan XE V6-2960cc 3.0L SOHC MFI (VG30E) (1998)
Throttle Full Close Switch: Testing and Inspection
COMPONENT INSPECTION
Closed throttle position switch
1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch "OFF".
3. Disconnect throttle position switch harness connector.
4. Check continuity between terminals (5) and (6) while opening throttle valve manually.
If NG, replace throttle position switch. To adjust it, perform "Basic Inspection".
See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Basic Inspection
Throttle position sensor
1. Disconnect throttle position sensor harness connector.
2. Make sure that resistance between terminals (2) and (3) changes when opening throttle valve manually.
If NG, replace throttle position sensor. To adjust it, perform "Basic Inspection"
See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Basic Inspection