Quest Minivan XE V6-2960cc 3.0L SOHC MFI (VG30E) (1998)
Diagnosis Sensor Unit: Service and Repair
CAUTION:
-
Before servicing SRS, turn the ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
-
The special bolts are coated with a bonding agent while the other bolt is for ground. Do not use old bolts after removal; replace with new bolts.
-
Check diagnosis sensor unit for proper installation.
-
Check diagnosis sensor unit to ensure that there are no deformities, dents, cracks or rust. If there are any visible signs of damage, replace with a
new one.
-
Check diagnosis sensor unit brackets to ensure they are free of deformities or rust.
-
Replace diagnosis sensor unit if it has been dropped or sustained an impact.
Diagnosis Sensor Unit
1. Disconnect driver and front passenger air bag module connectors.
2. Remove console box or CD magazine.
3. Disconnect and remove ABS control unit.
4. Disconnect diagnosis sensor unit connector.
5. Remove bolts from diagnosis sensor unit. Use TAMPER RESISTANT TORX (Size T50) to remove special bolts.
6. Remove the diagnosis sensor unit.
To install, reverse the removal procedure sequence.
After replacement, perform self-diagnosis for SRS. Refer to "Self-diagnosis", Diagnostic Procedure 1.
CAUTION: Diagnosis sensor unit must always be installed with arrow marks "<-" pointing towards the front of the vehicle for proper operation.
Also check diagnosis sensor unit for cracks, deformities or rust before installation and replace as required.