Rogue 2WD L4-2.5L (QR25DE) (2008)
4. Remove the reclining device inner and outer cover.
Assembly
Assemble in the reverse order of disassembly.
CAUTION: Install the hog rings of seatback trim in position, and then securely connect the trim or trim cord with the pad side wire.
SEATBACK (FOLDING SEAT)
Disassembly
1. Remove the seatback trim and seatback pad.
-
Remove the seatback retainer (1) on the back side of the seatback.
-
Unfasten fastener (2) on the back side of the seatback.
-
Remove the hog rings.
-
Remove the screw cap.
-
Remove the screws, and then remove seatback finisher.
-
Remove the side air bag module.
-
Remove the side air bag harness connector (A) and clamp.
-
Disconnect the seatback heater unit harness connectors
-
Remove the headrest holder.
CAUTION: Before installing headrest holder, check its orientation. (front/rear and right/left)
-
Remove the seatback trim and seatback pad from the seat frame assembly.
-
Remove the hog rings to separate the seatback trim and seatback pad.