Rogue 2WD L4-2.5L (QR25DE) (2008)
^ If there are two Engine lines (two ECM reprogramming options) on your C-III screen, use the one that does not have the message "Caution! Use
ONLY with NTBXX-XXX".
^ If there is not a match, this reprogramming does not apply or it has already been done. Close C-III and check Service Comm to confirm campaign
eligibility.
5. When ECM reprogramming is complete, the screen in Figure 2A displays.
NOTE:
If the screen in Figure 2A does not display (reprogramming does not complete) refer to NTB10-027.
6. Make sure to erase DTCs from all systems.
NOTE:
During reprogramming, DTCs will set in several systems and must be erased.
7. Go to IAVL below.
IAVL (Idle Air Volume Lean) Procedure
1. Make sure all DTCs are cleared (erased).
2. Use C-III to confirm / perform the following Pre-Conditions: