Rogue 2WD L4-2.5L (QR25DE) (2008)
Transmission Position Switch/Sensor: Adjustments
Inspection and Adjustment
ADJUSTMENT OF PNP SWITCH
1. Move selector lever to "N" position.
2. Remove control cable from manual lever.
3. Loosen mounting bolts (A) of PNP switch. Insert a pin [(diameter)4 mm (0.16 in)] into the adjusting holes (B) on both PNP switch and manual
lever for adjusting the position.
4. Tighten mounting bolts of PNP switch.
5. Install control cable to manual lever. Refer to TM-174, "WITHOUT MANUAL MODE: Inspection and Adjustment" (without manual mode),
TM-174, "WITH MANUAL MODE: Inspection and Adjustment" (with manual mode).
See: Transmission and Drivetrain/Continuously Variable Transmission/Transaxle/Shifter CVT/Testing and Inspection/Without Manual Mode
See: Transmission and Drivetrain/Continuously Variable Transmission/Transaxle/Shifter CVT/Testing and Inspection/With Manual Mode
ADJUSTMENT AFTER INSTALLATION
Adjust the CVT positions after installing control device. Refer to TM-174, "WITHOUT MANUAL MODE: Inspection and Adjustment" (without
manual mode), TM-174, "WITH MANUAL MODE: Inspection and Adjustment" (with manual mode).
See: Transmission and Drivetrain/Continuously Variable Transmission/Transaxle/Shifter CVT/Testing and Inspection/Without Manual Mode
See: Transmission and Drivetrain/Continuously Variable Transmission/Transaxle/Shifter CVT/Testing and Inspection/With Manual Mode
INSPECTION AFTER INSTALLATION
Check the CVT positions after adjusting the CVT positions. Refer to TM-174, "WITHOUT MANUAL MODE: Inspection and Adjustment" (without
manual mode), TM-174, "WITH MANUAL MODE: Inspection and Adjustment" (with manual mode).
See: Transmission and Drivetrain/Continuously Variable Transmission/Transaxle/Shifter CVT/Testing and Inspection/Without Manual Mode
See: Transmission and Drivetrain/Continuously Variable Transmission/Transaxle/Shifter CVT/Testing and Inspection/With Manual Mode