Rogue 2WD L4-2.5L (QR25DE) (2008)
1. Restart the C-III session (select the Home icon in the upper left corner of the screen).
2. Navigate C-III to the ECM Reprogramming screen shown in Figure 1A.
^ Use the "Reprogramming / Programming" selection.
^ Do not use Direct Diagnosis > Reprogramming.
3. On your C-III screen, look at the Part Number column (see Figure 1A example):
^ If this column is blank (no part number listed), this reprogramming does not apply. Close C-III and check Service Comm to confirm campaign
eligibility.
^ If a Part Number is listed, write it on the Repair Order.
4. Compare the Part Number you wrote down to the numbers in the Current ECM P/N column in Table A-1.
^ If there is a match, this bulletin applies. Continue with the reprogramming procedure.
NOTE