Rogue 2WD L4-2.5L (QR25DE) (2008)
-
Do not allow oil, grease, detergent or water to come in contact with the spiral cable.
-
Do not impact the spiral cable by dropping, etc. Replace the spiral cable if it has been dropped or sustained an impact.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
The spiral cable may snap during steering operation if the cable is installed in an improper position. The neutral position is set as follows.
-
Turn carefully the spiral cable clockwise to the end position. Then turn it counterclockwise (about 2 and a half turns) and stop turning at
the point (B) on which the stopper insertion holes are in the same position.
-
The service part is installed in the neutral position by the stopper and can be set without adjusting after the stopper is removed.
-
Do not over turn the spiral cable or go beyond number of turns required. (These will cause the cable to snap.)
-
Adjust the spiral cable locating pin (A) to the steering wheel locating pin hole (C).
-
In the case that a malfunction is detected by the air bag warning lamp, reset by the self-diagnosis function and delete the memory by
CONSULT-III.
-
In the case that a malfunction is still detected after the above operation, perform self-diagnosis to repair malfunctions.
-
After the work is completed, check that no system malfunction is detected by air bag warning lamp. Refer to SRC-18, "Diagnosis
Description". See: Testing and Inspection/Scan Tool Testing and Procedures/Diagnosis System (Airbag)