Rogue 2WD L4-2.5L (QR25DE) (2008)
3. Remove hose clamps (1), and remove CVT water hose A (2).
4. Remove hose clamps (1), and remove CVT water hose B (3).
5. Remove heater thermostat (4) from transaxle assembly.
6. Remove clip (<---).
7. Remove hose clamps (1), and remove CVT water hose C (2).
INSTALLATION
Note the following, and install in the reverse order of removal.
^
The illustrations indicate the view from the hose ends.<---
<---: Upper
^
When installing hose clamps the center line of each clamp tab should be positioned as shown in the figure.