Sentra L4-1.8L (QG18DE) (2004)
Air Bag Control Module: Service and Repair
Removal and Installation
REMOVAL
CAUTION:
-
Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait for at least 3 minutes.
-
Do not use old bolts after removal; replace with new ones.
-
Check diagnosis sensor unit for proper installation.
-
Check diagnosis sensor unit to ensure it is free of deformities, dents, cracks or rust. If they show any visible signs of damage, replace them with
new ones.
-
Check diagnosis sensor unit brackets to ensure they are free of deformities or rust.
-
Replace diagnosis sensor unit if it has been dropped or sustained an impact.
-
After replacement of diagnosis sensor unit, perform self-diagnosis for SRS. Refer to "SRS Operation Check" for details.
1. Disconnect driver, front passenger and front side air bag module connectors. Also, disconnect front seat belt pre-tensioner connectors.
2. Remove console box.
3. Disconnect diagnosis sensor unit connector.
4. Remove bolts from diagnosis sensor unit.
Then remove the diagnosis sensor unit.
INSTALLATION
NOTE: To install, reverse the removal procedure sequence.