Sentra L4-1597cc 1.6L DOHC MFI (GA16DE) (1991)
Inhibitor Switch: Adjustments
Except DX
Inhibitor Switch
1.
Remove control cable end from manual shaft, then set manual shaft in ``N'' range.
2.
Loosen inhibitor switch attaching bolts, then insert a .157 inch diameter pin into adjustment holes on both inhibitor switch and manual shaft as
near vertical as possible.
3.
Tighten inhibitor switch attaching bolts, then remove pin from adjusting hole.
4.
Install and adjust control cable, then check continuity of inhibitor switch.
Throttle Wire
Fig. 2 Throttle Wire Adjustment
1.
Turn ignition switch to Off position.
2.
While pressing lock plate, Fig. 2, move adjusting tube in direction ``T,'' then return lock plate.
3.
Move throttle drum from P2 to P1 quickly and ensure that throttle wire stroke ``L'' is 1.079-1.236 inch between full throttle and idle.
4.
Adjust throttle wire stroke when throttle wire/accelerator wire is installed and adjusted. Put mark on throttle wire to aid in measuring
wire stroke.