Sentra L4-2.0L (MR20DE) (2010)
Axle Shaft Assembly: Service Precautions
General Precautions
PRECAUTIONS
General Precautions
Observe the following precautions when disassembling and assembling drive shaft.
-
Joint sub-assembly does not disassemble because it is non-overhaul parts.
-
Perform work in a location which is as dust-free as possible.
-
Before disassembling and assembling, clean the outside of parts.
-
Prevention of the entry of foreign objects must be taken into account during disassembly of the service location.
-
Disassembled parts must be carefully reassembled in the correct order. If work is interrupted, a clean cover must be placed over parts.
-
Paper shop cloths must be used. Fabric shop cloths must not be used because of danger of lint adhering to parts.
-
Disassembled parts (except for rubber parts) should be cleaned with kerosene which shall be removed by blowing with air or wiping with paper
shop cloths.