Sentra L4-2.5L (QR25DE) (2003)
Seals and Gaskets: Service and Repair
RS6F51H
REMOVAL
1. Remove the drive shaft from the transaxle body.
2. Remove oil seal with a slotted screwdriver.
CAUTION: Be careful not to damage the case surface when removing the oil seal.
INSTALLATION
Installation is in the reverse order of removal.
^
Using Tool (drift), drive the new oil seal straight until it protrudes from the case end equal to dimension "A" as shown.
Dimension "A": Within 0.5 mm (0.02 inch) or flush with the case.
CAUTION:
^
Before installing oil seal, apply multi-purpose grease to oil seal lips.
^
Oil seal is not reusable.
^
Check oil level after installation.