Sentra GXE L4-1.8L (QG18DE) (2000)
2.
Remove two Screws that hold the Main Wiring Harness Support Bracket to the Strut Tower (see Figure 3).
3.
Disconnect the Rubber Vent Tube from the ECM Case Holder (see Figure 4).
4.
If equipped, remove two Screws and re-position the Manifold Absolute Pressure (MAP) Sensor (see Figure 5).
5.
Re-position the Throttle Cable Guide by removing it from the Metal Tab (see Figure 5).
6.
Remove two Screws that hold the ECM Case Holder to the engine room wall (see Figure 6).