Sentra SE-R Spec V L4-2.5L (QR25DE) (2002)
Submit a Primary Failed Part (PP) line claim using the claims coding table.
SERVICE PROCEDURE
Replace the M/T Console Boot as follows:
1.
Unscrew and remove the M/T Shift knob.
2.
Remove the old M/T Console Boot assembly. Refer to the applicable Service Manual for removal.
3.
Install the new M/T Console Boot assembly in the reverse order it was removed.
NOTE:
Before you install the new M/T Console Boot assembly:
^
Clean the Flange Bracket (on the shifter) to remove dirt/debris/residue.
^
Apply (wrap) four layers of vinyl (electrical) tape around the Flange Bracket (see Figure 1). This will help prevent contact/rubbing
between the Flange Bracket and the Console Boot.
4.
Reinstall the Shift knob.