Sentra XE L4-1.8L (QG18DE) (2000)
Repairs and Inspections Required After a Collision: Service and Repair
Air Bag System
Repairs and Inspections Required After A Collision
FOR FRONTAL COLLISION
To repair the SRS, perform the following steps.
When SRS (except the side air bag) is activated in a collision:
1. Replace the diagnosis sensor unit.
2. Remove the air bag modules (except the side air bag module) and front seat belt pre-tensioner assemblies.
3. Check the SRS components using the table shown below:
Replace any SRS components showing visible signs of damage (dents, cracks and deformation).
4. Install new air bag modules (except the side air bag module) and front seat belt pre-tensioner assemblies.
5. Conduct self-diagnosis using CONSULT-II or "AIR BAG" and "SEAT BELT" warning lamp. Refer to "Self-diagnosis" for details.
SEE DIAGNOSTIC PROCEDURE 1 AND 2.
See: Air Bag Systems/Testing and Inspection/Component Tests and General Diagnostics
See: Air Bag Systems/Testing and Inspection/Component Tests and General Diagnostics/Diagnostic Procedure 2
Ensure entire SRS operates properly.
Part 1 Of 2