Titan 2WD V8-5.6L (VK56) (2004)
12. Remove and replace the switch.
13. Secure the switch harness with the 2 clips to the seat pan.
14. Roll the side facing trim down over the new seat switch. Re-attach the loose J-Clip back onto the seat frame.
^ Make sure the upholstered edge is flat and smooth with no bumps. See Figure 9.
^ Make sure the upholstered edge is flat and level with the side of the switch. See Figure 9.
WARNING:
Make sure the J-Clip is securely attached. A loose J-Clip may affect OCS performance.
15. Install the switch plate and switch knobs.
16. Set the seat pan back onto the seat frame and secure with the 4 bolts.
Torque 27.5 Nm (2.8 Kg-m, 20 ft-lb).
17. Re-attach the seat harnesses to the seat pan.
18. Re-attach the lower flap cover.