Titan 2WD V8-5.6L (VK56) (2004)
Air Bag(s) Arming and Disarming: Service and Repair
Precautions for SRS "AIR BAG" and "SEAT BELT PRE-TENSIONER" Service
-
Do not use electrical test equipment to check SRS circuits unless instructed.
-
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after
the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or
wires until at least 3 minutes have passed.
After repairs have been performed,
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Diagnostic Procedures/Air Bag System/Diagnostic Test Procedures
then See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Diagnostic Procedures/Air Bag System/Diagnostic Test Procedures/Diagnostic Procedure 3