Titan 2WD V8-5.6L (VK56) (2004)
units in the system. Each control unit transmits/receives data, but selectively reads required data only.
BCM STATUS CONTROL
BCM changes its status depending on the operation status in order to save power consumption.
1. CAN communication status
-
With ignition switch ON, CAN communicates with other control units normally.
-
Control by BCM is being operated properly.
-
When ignition switch is OFF, switching to sleep mode is possible.
-
Even when ignition switch is OFF, if CAN communication with IPDM E/R and combination meter is active, CAN communication status is
active.
2. Sleep transient status
-
This status shuts down CAN communication when ignition switch is turned OFF.
-
It transmits sleep request signal to IPDM E/R and combination meter.
-
Two seconds after CAN communication of all control units stops, CAN communication switches to inactive status.
3. CAN communication inactive status
-
With ignition switch OFF, CAN communication is not active.
-
With ignition switch OFF, control performed only by BCM is active.
-
Three seconds after CAN communication of all control units stops, CAN communication switches to inactive status.
4. Sleep status
-
BCM is activated with low current consumption mode.
-
CAN communication is not active.
-
When CAN communication operation is detected, it switches to CAN communication status.
-
When a state of the following switches changes, it switches to CAN communication state:
-
Key switch
-
Hazard switch
-
Door lock/unlock switch
-
Front door switch (LH, RH)
-
Rear door switch (LH, RH)
-
Combination switch (passing, lighting switch 1st position, front fog lamp)
-
Key fob (lock/unlock signal)
-
Key cylinder switch
-
When control performed only by BCM is required by switch, it shifts to CAN communication inactive mode.
-
Status of combination switch reading function is changed.
SYSTEMS CONTROLLED BY BCM DIRECTLY
-
Power door lock system.
-
Remote keyless entry system.
-
Power window system.
-
Sunroof system.
-
Room lamp timer.
-
Warning chime system.
-
Turn signal and hazard warning lamps system.
NOTE: Power supply only. No system control.
SYSTEMS CONTROLLED BY BCM AND IPDM E/R
-
Panic system.
-
NVIS (NATS) system. Refer to Component Parts and Harness Connector Location, "NVIS(NISSAN Vehicle Immobilizer System-NATS)".
-
Headlamp, tail lamp, auto light and battery saver control systems.
-
Front wiper and washer system.