Titan 2WD V8-5.6L (VK56) (2004)
Electronic Brake Control Module: Service and Repair
ABS
ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)
Removal and Installation
REMOVAL
1. Disconnect the negative battery terminal.
2. Remove the cowl top extension.
3. Drain the brake fluid.
4. Disconnect the actuator harness from the ABS actuator and electric unit (control unit).
CAUTION:
^
To remove the brake tubes, use a flare nut wrench to prevent the flare nuts and brake tubes from being damaged.
^
Be careful not to splash brake fluid on painted areas.
5. Disconnect the brake tubes.
6. Remove the three bolts and remove the ABS actuator and electric unit (control unit).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: To install, use a flare nut wrench (commercial service tool).
^
Always tighten brake tubes to specification when installing.
^
Never reuse drained brake fluid.
^
After installation of the ABS actuator and electric unit (control unit), refill brake system with new brake fluid. Then bleed the air from the system.