Titan 2WD V8-5.6L (VK56) (2004)
d.
Unplug the white 3-Wire Connector at the top of the fuel pump (see Figure 3).
^
Do NOT disturb the black 2-Wire Connector located next to the white connector
e.
Carefully cut the Tie-Wrap securing the harnesses to the black Corrugated Tubing (see Figure 3).
CAUTION:
Do NOT damage the wires or the wire insulation when cutting the Tie-Wrap.
4.
Install the new Fuel Level Sending Unit as follows:
CAUTION:
Do NOT bend the Float Arm when handling the Fuel Level Sending Unit/Fuel Pump Assembly.