Titan 2WD V8-5.6L (VK56) (2004)
5.
Remove the LH Instrument Lower Cover next to the Accelerator Pedal (see Figure 5).
^
Carefully pull outward to release the Securing Clips.
6.
If the BCM needs to be replaced as confirmed by Procedure A Terminal Check, go ahead and replace the BCM now. Then continue with step # 8
(below).
^
Remove all three Harness Connectors from the BCM (see Figure 6).
^
Remove the two BCM Mounting Bolts and remove BCM (see Figure 6).
^
Install new BCM.
^
Reconnect the top connector ONLY (as viewed in Figure 6).
7.
If the BCM does not need to be replaced,
^
Install the new Sub-Harness.
^
Start by disconnecting ONLY the two vertical Connectors at the BCM (see Figure 6).