Titan 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
Steering Gear: Removal and Replacement
POWER STEERING GEAR AND LINKAGE
Removal and Installation
CAUTION:
Spiral cable may snap due to steering operation if steering column is separated from steering gear assembly. Therefore secure steering wheel
to avoid turning.
REMOVAL
1. Turn wheels to the straight-ahead position.
2. Remove wheel and tire from vehicle using power tool.
3. Remove undercover using power tool.
4. On 4WD model, remove front final drive, then support drive shafts with wire. Refer to See: Transmission and Drivetrain/Differential
Assembly/Service and Repair/Removal and Replacement/Front Final Drive M205.
5. Make sure slit of lower joint "A" fits with the projection on rear cover cap "B", while checking that mark on steering gear assembly aligns with
mark on rear cover cap.
6. Remove cotter pin at steering outer socket and discard, then loosen nut.