Titan 4WD V8-5.6L (VK56DE) (2006)
^
Assemble adjuster so that threaded part expands when rotating it in the direction shown by the arrow.
^
Shorten adjuster by rotating it.
NOTE: After replacing brake shoes or disc rotors, or if brakes do not function well, perform break-in operation as follows.
1. Adjust parking brake pedal stroke.
CAUTION:
^
To prevent lining from getting too hot, allow a cool off period of approximately 5 minutes after every break-in operation.
^
Do not perform excessive break-in operations, because it may cause uneven or early wear of lining.
2. Perform parking brake burnishing operation by driving the vehicle forward under the following conditions:
^
Vehicle speed at 40 km/h (25 MPH)
^
Parking brake operating force of 196 N (20.0 kg, 44.1 ft. lbs.) set
^
For a period of 30 seconds
3. After burnishing operation, check pedal stroke of parking brake. Readjust if it is no longer at the specified stroke.