Titan 4WD V8-5.6L (VK56DE) (2006)
1. Assemble the journal bearings. Apply multipurpose grease on the bearing inner surface.
NOTE: During assembly, use caution so that the needle bearings do not fall down.
2. Select snap rings that will provide the specified play in an axial direction of the journal, and install them. Refer to "Snap Ring". See:
Specifications/Snap Ring
NOTE: Select snap rings with a difference in thickness at both sides within 0.02 mm (0.0008 inch).
3. Adjust the thrust clearance between the bearing and snap ring to zero by tapping the yoke.
4. Make sure that the journal moves smoothly and is below the propeller shaft joint flex effort specification.
Propeller shaft joint flex effort: 1.96 Nm (0.20 kg-m, 17 inch lbs.) or less