Titan 4WD V8-5.6L (VK56DE) (2006)
Control Module: Service and Repair
Removal and Installation
TRANSFER CONTROL UNIT
Removal and Installation
REMOVAL
1. Switch 4WD shift switch to 2WD and set transfer assembly to 2WD.
2. Remove the glove box assembly.
3. Disconnect transfer control unit connectors.
4. Remove the transfer control unit.
INSTALLATION
Installation is in the reverse order of removal.
^
When installing the transfer control unit, tighten bolts to the specified torque.
Transfer control unit bolts: 5.1 Nm (0.52 kg-m, 45 inch lbs.)
^
After the installation, check 4WD shift indicator pattern. If NG, adjust position between transfer assembly and transfer control unit. See: Service
Precautions/Vehicle Damage Warnings/Precautions For Transfer Assembly and Transfer Control Unit Replacement