Versa L4-1.6L (HR16DE) (2010)
Idler Pulley: Service and Repair
Removal And Installation
DRIVE BELT IDLER PULLEY
Removal and Installation
REMOVAL
1. Remove drive belt. See: Drive Belt/Service and Repair/Removal and Replacement.
2. Remove the lock nut, and then remove the plate, idler pulley, and washer.
3. Remove the center shaft together with the spacer with inserting the adjusting bolt.
INSTALLATION
1. Insert the center shaft (1) into the slide groove of the spacer (2).
Fully screw in the adjusting bolt (3) in the belt loosening direction ( Arrow Indicates).
-
At that time, place the flange (a) of the adjusting bolt and the seat (b) of the center shaft on the spacer.
2. Place each surface (c, d) of the spacer on the generator bracket.
Install the washer, idler pulley, and plate, and then temporarily tighten the lock nut.
: 4.4 N.m (0.45 kg-m, 39 in-lb)
3. Installation is in the reverse order of removal.