Versa L4-1.6L (HR16DE) (2010)
Technical Service Bulletin # 10-027A
Date: 100405
Engine Controls - ECM Reprogram Interruption Recovery
Classification: EC10-007A
Reference: NTB10-027A
Date: April 5, 2010
ECM REPROGRAM INTERRUPTION RECOVERY
This bulletin has been amended. 2010 Versa has been added to the Applied Vehicles. Please discard previous version of this bulletin.
APPLIED VEHICLES:2008 - 2010 Rogue (S35)
2010 Versa (C11) with HR16DE or MR18DE engine
IF YOU CONFIRM
While performing ECM (Engine Control Module) reprogramming, the reprogramming stops (is interrupted) before it is 100% complete.
NOTE:
One of the following error messages may appear on the C-III screen:
^ The VI probe is disconnected on USB, please check the connection of the probe.
^ Reprogramming fail, "Error code 0".
ACTION
Perform the reprogramming recovery procedure in this bulletin.
NOTE:
^ In many cases, reprogramming recovery is possible if the complete ECM part number has been registered into the ECM before reprogramming
stopped.
^ ECM is referred to as ECU in CONSULT III.
CLAIMS INFORMATION
The procedure in this bulletin is part of the reprogramming process. Submit only the claim associated with the repairs performed for ECM
reprogramming.
Service Procedure
ECM Reprogramming Recovery Procedure
1. Turn the ignition OFF (keep it off for at least 10 seconds).
2. Close / turn OFF the CONSULT-III program.
IMPORTANT:
Before performing any reprogramming, make sure:
^ ASIST on the C-III computer has been freshly synchronized (updated).
^ All C-III software updates (if any) have been installed.
NOTE:
The C-III computer automatically gets applicable ECM reprogramming data during ASIST synchronization.
3. Make sure the following are connected: