nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

How To Set SRT Code|Page 1598 > < How To Set SRT Code|Page 1596
Page 3
background image

-

When steady-state driving is performed again even after it is interrupted, each diagnosis can be conducted.

In this case, the time required for diagnosis may be extended.
Pattern 3:

-

Operate vehicle following the driving pattern shown in the figure.

-

Release the accelerator pedal during decelerating vehicle speed from 90 km/h (56 MPH) to 0 km/h (0 MPH).

Pattern 4:
-

The accelerator pedal must be held very steady during steady-state driving.

-

If the accelerator pedal is moved, the test must be conducted again.

*1: Depress the accelerator pedal until vehicle speed is 90 km/h (56
MPH), then release the accelerator pedal and keep it released for more than 10 seconds. Depress the accelerator pedal until vehicle speed is 90 km/h
(56 MPH)
 again.
*2: Checking the vehicle speed with GST is advised.

Suggested Transmission Gear Position for A/T Models
Set the selector lever in the D position.

Suggested Upshift Speeds for M/T Models
Shown below are suggested vehicle speeds for shifting into a higher gear. These suggestions relate to fuel economy and vehicle performance. Actual
upshift speeds will vary according to road conditions, the weather and individual driving habits.

How To Set SRT Code|Page 1598 > < How To Set SRT Code|Page 1596