Xterra 2WD V6-4.0L (VQ40) (2005)
![background image](/nissan/xterra_2wd/v6-4.0l_(vq40)/Page-2178002.png)
6. Raise the rear door glass and hold it in place with suitable tool.
7. Remove the bolts and the regulator assembly.
-
If equipped, disconnect the connector from the regulator assembly.
INSPECTION AFTER REMOVAL
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
-
Gear wear
-
Regulator deformation
-
Spring damage
-
Grease condition for each sliding part
INSTALLATION