Xterra 2WD V6-4.0L (VQ40) (2005)
^ If it applies: Position the band clamp(s) between the "dimples or on top where the "stand-offs" are located (see Figure 1 and 2 above).
>
The "stand-offs" cannot be seen: They are welded on the underside of the heat shield.
>
If the "stand-off" is missing, this bulletin does not apply.
5. Secure the band clamp with the hex bolt located on the side (or on top, if needed). See Figure 1 above for example.
WARNING:
Do Not install the hex bolt on the bottom of the exhaust tube.
^ Band clamp hex bolt torque: 4.0 - 5.5 Nm (0.4 - 0.56 Kg-m, 2.9 - 4.0 ft-lb)
6. After securing the band clamp, cut off the clamp's excess at the end.
^ Wrap the end of the band clamp over the hex bolt, and then cut off the excess band clamp within 5 mm (0.2 inches) past the hex bolt (see Figure 2 for
example).