Xterra 2WD V6-4.0L (VQ40) (2005)
9. Remove splash guard and wheel hub and bearing assembly from steering knuckle.
CAUTION: Do not pull on wheel sensor harness.
10. Remove cotter pin and nut from upper link ball joint.
11. Separate upper link ball joint from steering knuckle using Tool.
Tool number: ST29020001 (J-24319-01)
12. Remove pinch bolt from steering knuckle using power tool, then separate lower link ball joint from steering knuckle.
13. Remove steering knuckle from vehicle.
INSTALLATION
Installation is in the reverse order of removal.
^
Refer to "Components for tightening torques".
CAUTION: Always replace drive shaft lock nut and cotter pin.
^
When installing disc rotor on wheel hub and bearing assembly, align the marks.
NOTE: When not using the alignment mark, refer to "Front Disc Brake".
^
When installing wheel and tire, refer to "Rotation".
^
Perform wheel alignment. Refer to "Front Wheel Alignment".
Inspection After Removal
INSPECTION AFTER REMOVAL
Check for deformity, cracks and damage on each part, replace if necessary
^
Perform ball joint inspection. Refer to "Inspection".