Xterra SE 2WD V6-3.3L (VG33E) (2002)
14.
Remove the ECU Reprogramming card from slot A of CONSULT-II and install the Diagnostics (red/white) card into slot A (see Figure 14).
CAUTION:
Do not use slot B (bottom slot).
15.
Turn "ON" the ignition switch (do not start the engine). CONSULT-II will turn on automatically (see Figure 15).
16.
Press "START" and select "ENGINE".
17.
Press "SELF-DIAG RESULTS" and confirm that no DTC(s) exist.
^
If no DTC(s) exist, proceed to step 18.
^
If DTC(s) exist, print them, then erase the DTC(s) and proceed to step 18.
NOTE:
Additional repairs may be necessary if the DTC's are not associated with a Reprogramming bulletin. Refer to the appropriate Service Manual.
18.
Press "BACK" three times to return to the CONSULT-II main menu.
Step 2: Confirm CONSULT-II Battery Voltage
19.
Disconnect CONSULT-II from the vehicle and the AC/DC power cord.
20.
Press "SUB MODE", then select "BATTERY CHARGE".