nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

SRS System - Warning Lamp Flashing/DTC Stored|Page 8803 > < Recall 03C061000: Air Bag Clockspring Modification
Page 1
background image

Clockspring Assembly / Spiral Cable: All Technical Service Bulletins
SRS System - Warning Lamp Flashing/DTC Stored

Classified:
RS01-008

Reference:
NTB01-092

Date:
December 18, 2001

2002 XTERRA; AIR BAG WARNING LAMP IS FLASHING AND DRIVER AIRBAG MODULE [SHORT] CODE STORED

APPLIED VEHICLE(S):
2002 XTERRA (WD22)

APPLIED VIN(S):
Built before 5N1ED28Y22C528104

APPLIED DATE(S):
Built before November 1, 2001

SERVICE INFORMATION

If an applied vehicle has the following symptoms:

^

Air bag warning lamp is flashing or steady on.

^

CONSULT II shows the following Diagnostic code:

DRIVER AIRBAG MODULE (SHORT]

Replace the steering wire assembly (spiral cable) and the driver side air bag module if the described symptoms should occur.

Note: 

DRIVER AIRBAG MODULE [OPEN] code may be stored if the connectors of the spiral cable are disconnected from the driver air bag module.

SERVICE PROCEDURE

1.

Verify the incident.

2.

Remove the driver side air bag module and the steering wire assembly (spiral cable).

^

Use special tool P/N J44615 or J42057 (Air Bag Lock Master Key Set) to remove the air bag module if fastened with accessory anti-theft
bolts.

IMPORTANT:

Refer to the following 2002 Xterra Service Manual pages:
^

Precautions-RS 10

^

Driver Air Bag Module and Steering Wire Assembly (spiral cable) Removal/Installation RS 16-18

3.

Disconnect the spiral cable harness connector as follows:

A.

Note the position (color) of the harness connector.

SRS System - Warning Lamp Flashing/DTC Stored|Page 8803 > < Recall 03C061000: Air Bag Clockspring Modification