Xterra SE 2WD V6-3.3L (VG33E) (2002)
INSTALLATION
1. Set the front wheels in the straight-ahead position.
2. Align the turn signal cancel tab with the notch of the combination switch as shown.
3. Rotate the spiral cable fully clockwise until tight.
4. Rotate the spiral cable counterclockwise approximately 2.25 turns and align white pin with arrow on housing.
-
When the spiral cable is centered, white pin is aligned with arrow on housing and yellow wheel shows in window.
CAUTION:
-
The spiral cable may snap during steering operation if the spiral cable is installed in an improper position.
-
Also, with the steering linkage disconnected, the cable may snap by turning the steering wheel beyond the limited number of turns. The spiral
cable can be turned counter-clockwise approximately 2.25 turns. Always perform SRS self-diagnosis after installing the air bag module. Refer
to "SRS Operation Check" for details.
5. Connect spiral cable to air bag harness and tighten screws. Install steering column covers.