Xterra SE 2WD V6-3.3L (VG33E) (2002)
Wheel Hub: Service and Repair
Disassembly, Inspection and Assembly
Wheel Hub and Rotor Disc
DISASSEMBLY
Remove grease seal and bearing outer races with suitable brass bar.
INSPECTION
Thoroughly clean wheel bearings and wheel hub.
Wheel Bearings
Make sure wheel bearings roll freely and are free from noise, cracks, pitting and wear.
Wheel Hub
Check wheel hub for cracks by using a magnetic exploration or dyeing test.
ASSEMBLY
1. Install bearing outer race with Tool until it is fully seated in hub.
2. Install the sensor rotor using suitable drift and press. Always replace sensor rotor with new one. Pay attention to the direction of front sensor rotor
as shown in figure.