Xterra SE 2WD V6-3.3L (VG33E) (2002)
4-2 sequence valve and relay valve are located far back in upper body. If they are hard to remove, carefully push them out using stiff wire.
Be careful not to scratch sliding surface of valve with wire.
Inspection
INSPECTION
Valve Springs
Measure free length and outer diameter of each valve spring. Also check for damage or deformation.
Replace valve springs if deformed or fatigued.
Control Valves
Check sliding surfaces of valves, sleeves and plugs.
Assembly
ASSEMBLY
1. Lubricate the control valve body and all valves with ATF. Install control valves by sliding them carefully into their bores.
Be careful not to scratch or damage valve body.
Wrap a small screwdriver with vinyl tape and use it to insert the valves into proper position.