Xterra SE 4WD V6-3.3L (VG33E) (2000)
19. Re-install the fuel tank. Refer to the "FE" section in the applicable Service Manual.
IMPORTANT:
^
Make sure the hoses removed from the fuel tank are correctly installed to the same pipes they were removed from.
^
Make sure the Fuel Sending Unit Wire Harness Connectors are securely locked into position.
^
Make sure all Fuel/EVAP hoses are in good condition (no cracks, splits, etc.) and are securely reconnected to prevent leaks.
20. Re-assemble all previously removed components in the reverse order you removed them.
21. Start the vehicle and confirm proper engine running and fuel gauge operation.
Inspect Fuel Sending Unit
Xterra: Inspect Fuel Sending Unit
CAUTION:
Use suitable covers to protect carpet, upholstery, paint, etc. when performing this procedure.
1. Remove the rear, passenger-side, bottom Seat Cushion as follows:
a. Pull on the Seat Cushion Release Straps while lifting UP on the front edge of the Seat Cushion (see Figure 23).
b. Remove the Cushion and place it in a clean, safe location.