Xterra XE 4WD V6-3.3L SC (VG33ER) (2002)
To inspect components under the hood, start by verifying the integrity of ground connections.
First check that the system is properly grounded. Then, check for loose connection by gently shaking the wiring or components as previously explained.
Using the wiring diagrams, inspect the wiring for continuity.
Behind the instrument panel
An improperly routed or improperly clamped harness can become pinched during accessory installation. Vehicle vibration can aggravate a harness which
is routed along a bracket or near a screw.
Under seating areas
An unclamped or loose harness can cause wiring to be pinched by seat components (such as slide guides) during vehicle vibration. If the wiring runs
under seating areas, inspect wire routing for possible damage or pinching.
Water Intrusion
WATER INTRUSION
The incident may occur only during high humidity or in rainy/snowy weather. In such cases the incident could be caused by water intrusion on an
electrical part. This can be simulated by soaking the car or running it through a car wash.
Do not spray water directly on any electrical components.
CONSULT-II Checking System