Xterra XE 4WD V6-3.3L SC (VG33ER) (2002)
22.
Go back along the jumper wire entire length. Double check and make sure you've used enough tie-wraps to secure the jumper wire to the body
harness between ground points M68 and B106 (see Figures 9 through 13).
23.
Cut off excess length on each tie-wrap.
24.
Place the body harness back into its position and reinstall covers and mounting screws.
25.
Reinstall the following items:
^
Fuel level sending unit access cover
^
Put floor insulation and carpet back in place
^
Right rear passenger seat bottom cushion
^
Right side front and rear "kicking plates" (door sill covers)
^
Right front kick panel
^
Right front seat belt floor anchor bolts (located at the base of the B pillar). Torque these anchor bolts to 43.1 68.6 N-m, (4.4-7.0 kg-m, 32-50
ft-lb.).
^
Front passenger seat (make sure to connect the seat belt harness connector). Torque the bolts to 43-55 N-m, (4.4-5.6 Kg-m, 32-41 ft-lb.).
26.
Refuel the vehicle. Check for proper operation and that there are no fuel leaks.
27.
Erase the DTC using CONSULT-II. Return the vehicle to the customer.