Xterra XE 4WD V6-3.3L SC (VG33ER) (2002)
Electronic Brake Control Module: Service and Repair
REMOVAL
1. Disconnect battery cable.
2. Drain brake fluid.
3. Remove mounting bracket fixing bolts and nuts.
4. Disconnect connector, brake pipes and remove fixing nuts and actuator ground cable.
INSTALLATION
CAUTION: After installation, refill brake fluid. Then bleed air.
1. Tighten actuator ground cable.
Place ground cable at a notch of mounting bracket.
2. Connect brake pipes temporarily.
3. Tighten fixing bolts and nuts.
4. Tighten brake pipes.
5. Connect connector and battery cable.